01Why fly two spacecraft together?#
SpaDeX, the Space Docking Experiment, was an ISRO technology demonstration of rendezvous, docking, and undocking in low Earth orbit. Its two spacecraft were each about 220 kg: SDX01, also called SpaDeX-A, served as the chaser, while SDX02, or SpaDeX-B, was the target. PSLV-C60 placed them in a 470 km circular orbit inclined 55° to the equator on 30 December 2024. In-space docking lets separately launched spacecraft join to carry out a shared mission, a capability relevant to future Indian missions; those future missions are applications, not outcomes guaranteed by SpaDeX.[1][2]
ISRO described SpaDeX as a cost-effective demonstrator using two small spacecraft with docking mechanisms. The nominal architecture assigned SDX01 as chaser and SDX02 as target. They entered a 470 km circular orbit at 55° inclination after the PSLV-C60 launch on 30 December 2024. The experiment addressed autonomous relative navigation and controlled contact, capabilities that can support missions requiring separate launches to assemble or operate a combined system. The demonstration establishes those capabilities in this mission; it does not establish that any particular planned mission will fly.[1][2]
02Finding and joining the target#
Docking begins well before the spacecraft touch. The chaser must estimate where the target is, approach in controlled steps, and align the two vehicles so their mechanisms can connect at low speed. SpaDeX demonstrated autonomous rendezvous and low-impact docking, including vertical and radial docking operations. This is a close-range application of orbital mechanics: small changes in velocity change the spacecrafts’ relative paths, so the approach has to be planned and measured carefully.[1][2]
ISRO’s design uses relative orbit determination and propagation, inter-satellite communications, rendezvous sensors, and a sequence of closing and hold points. The mission description identifies differential GNSS carrier-phase measurements exchanged over an inter-satellite link as inputs to relative position and velocity estimates. At closer ranges, laser-based and proximity sensors support the approach. Guidance then reduces separation through staged relative-motion manoeuvres before contact. The published mission description explains this architecture; ISRO’s later mission-end account confirms that vertical and radial docking were accomplished, without publishing a full error budget or a complete time history in that summary.[1][2]
03What the demonstration accomplished#
ISRO reports that the spacecraft completed vertical and radial docking, composite control while joined, electrical power transfer, undocking, and payload operations. The mission also demonstrated circumnavigation, in which one spacecraft moved around the other. These operations tested more than mechanical contact: they exercised coordinated control and the ability to separate again and continue operating.[2]
The reported results span the mission sequence: autonomous relative motion, two docking geometries, control of the combined configuration, transfer of electrical power across the docked interface, separation, payload operations, and circumnavigation. The mission page lists rendezvous and docking, undocking, power transfer, composite control, and post-undocking payload operations as objectives; ISRO’s 23 October 2026 account states that these core objectives and circumnavigation were accomplished. This supports describing them as demonstrated mission outcomes, without inferring performance margins that the cited summary does not provide. The work is an example of integrated spacecraft systems engineering.[1][2]
04Re-entry after operations#
After the operational phase, fuel in both spacecraft was exhausted and their orbits gradually decayed. ISRO says moderate geomagnetic storms on 4 and 11 October 2026 accelerated that decay, but its report does not quantify how much they contributed. Both satellites re-entered on 12 October: SpaDeX-A’s impact point was over the South Pacific at about 16:48 UTC, and SpaDeX-B’s was over the North Atlantic at about 23:36 UTC. ISRO reports that the spacecraft remained healthy until the final telemetry frames were received.[2]
ISRO attributes the end of the orbital phase to fuel exhaustion followed by progressive orbital decay, with moderate geomagnetic storms on 4 and 11 October accelerating the decay. The agency gives no quantitative apportionment of the storms’ effect, so the rate or magnitude of that contribution cannot be stated from this report. Its reported re-entry and impact times are approximately 16:48 UTC for SpaDeX-A over the South Pacific and 23:36 UTC for SpaDeX-B over the North Atlantic on 12 October 2026. The mission-end account says telemetry continued until each spacecraft’s final frames.[2]
